Monday, March 23, 2015

Pz Kpfw II Detail



The final model of the development series was the Ausf c, which bore the external features that came to be recognized as the standard design for the Pz Kpfw II. The Ausf c retained the 13mm armour of the Ausf b. The Ausf A was the first production series and was built from July 1937. The Ausf B was produced from December 1937, the Ausf C, from June 1938. 


With the Ausf c, the suspension was changed from six small road wheels to five independently sprung larger diameter road wheels, and the number of return rollers was increased from three to four. The track design was changed (which meant that the drive sprockets had to be modified) and wider fenders and idler wheels were installed. The ventilation and cooling of the engine compartment was again improved. The final drives and epicyclic steering system on 25 of the Ausf c were manufactured from an 'ersatz (substitute) molybdenum' steel.

The last major change in the Pz Kpfw II series was the introduction of an improved transmission in the Ausf A. There were only minor differences (mainly changes to the vision ports) between the Ausf A, B and C. As originally produced, all the Pz Kpfw II Ausf c, A to C had a split hatch on the turret roof for the commander, and a rounded hull front. The Polish anti-tank rifle could easily penetrate the 15mm armour of the Pz Kpfw II an d the troops requested that it be strengthened. By May 1940, additional 20mm armour plates had been bolted to the front of the turret, superstructure and hull front of approximately 70 per cent of the Pz Kpfw II Ausf c to C, and the armour of the remainder had been increased before the invasion of Russia.

During the campaign in Poland, commanders had complained of limited vision, and had registered the same complaint during the campaign in the West. From October 1940, this defect was remedied by the provision of a kit with eight periscopes for the commander's cupola.

No comments:

Post a Comment